Verkaufsliste

machine width: 2550mm

Max. speed: 200 m/min

BW range: 30-400grs/m²

Supply voltage: 3 x 500 Volts

Steam pressure: 4 bar

Air pressure: 7 bar

Water pressure: 2 bar

Water consumption: 40 Lts/Kg

Steam consumption: 3.0 Kg/kg

PM only from headbox to pope-roll.

MACHINE DESCRIPTION

Has produced a wide range of products:
Fine papers, 60 to 220 GSM with watermark and deep colors. High quality board papers up to 400 GSM
Other specialty papers from 30 to 90 GSM

Production range is from 30 to 400 GSM running at 50 to 220 m/min.

Paper with at reel is 2550 mm max.

Capacity is up to 3500 Kg/h.

Main characteristics is its formation uniformity CM and MD, gradual drying rate both wet and steam dried.

GENERAL DESCRIPTION

FORMING SECTION WITH DANDY ROLL

It is a Fourdrinier type with removable table for wire change, cantilever couch roll, closed headbox for optimal flow rate at any speed and watermarking Dandy Roll.

PRESSES

Three 80 kg /cm2 presses, 2 lower felt and a 3rd upper felt, allowing good drying capacity and surface smoothing.

Water content after presses is about 50% below 120 GSM.

DRYING

Consist in a main battery of 18 driers of 1250 mm diameter, in 3 drive sections with drying felts on both sides.

Post drying after size press is done with 6 driers, 4 of 1000mm dia and 2 1250mm diameter in one drive section, with automatic paper moisture control.

All driers tested at 4 Bar, heated with steam at 3.7 Bars max.

All sections covered by a recovery heat hood that allows pocket ventilation at 90 degrees Celcius.

SIZE PRESS

Two rubber 350 mm diameter rolls working at 20 Kg/cm allows sizing with starch and latex.

CALENDER STACK

Küsters 400mm dia King roll, 2 intermediate 330mm dia rolls and un upper 400mm dia Queen roll that can be used as a one pass or three pass calender up to 80 Kg/cm.

MACHINE DRIVE

It is a line shaft with conical pulleys, pneumatic clutch and angular reducer for 11 sections. Motor drive is 300 Kw dc.

SECURITY PAPER MACHINE

• ·  Deckle : 2,55m
• ·  Max Speed : 220m/min
• ·  Basis weight range : 40/400gsm
• ·  Headbox : pressurized / Stainless steel built in 2003
• ·  Fourdrinier with foils, 6 vacuum boxes, Couch Roll with vacuum
• ·  2 vertical presses with bottom felt – max 80kg/cm
• ·  1 vertical presses offset – max 80kg/cm
• ·  18 Drying cylinder – Diameter 1,25 m – 3,7 ata steam pressure
• ·  Inclined Size-Press – working pressure 20kg/cm
• ·  6 Drying cylinder – Diameter 4×1,0m + 2×1,25 m – 3,7 ata steam pressure
• ·  High efficiency hood
• ·  Machine Calender – 3 NIPs – Kuster bottom roll
• ·  Vertical Reel up (Pope
• ·  ABB supervision & gauges for Moisture & basis weight control

• Product portfolio
• 1). security papers, like for checkbooks, fiscal stamps, minutes for notaries
• 2.) papers for wine labels,
• 3.)  bristol cardboard for various commercial applications, like posters, bookstore, 
• 4.) papers with watermark, 
•  
• 4.) plasterboard

• Operational Features: The very versátiles headbox with both option to run either with vacuum or with pressure between 0.5 abd 1.15 % of consistency and a forming table with a vacuum system, that let the operators to work with less or more water on the table…

• It had a very flexible, multiple  vacuum system, where you could easaly regulate the amount of water to handled on the table…

• Production Mix : ThePM was continuously switching from one grade to another,  between 40 and 330 gr/sqm of basisweight. 

4 units press rolls, rubber lined, made by Bellmer

2550 mm net width at pope reeler

weight per unit ca 15 tons

Tissue Verarbeitungsmaschine für Toilettenpapier oder Küchenrollen bestehend aus:

• Nested Embosser (Prägestation)
• Rewinder
• Tail Sealer (Endblattverleimung)
• Hülsenmaschine samt Hülsentransport und -bevorratung
• Stangenspeicher
• Kreismesser (2x)
• Röllchentransport

Für Toilettenpapier oder Küchenrolle

Centrifugal pump in good condition

Made by Allweiler / Germany

Capacity: 120 m³/h

Pump height: 20 m

Required RPM: 1450

Housing made in cast iron

PCMC 200

Rewinder:

Refurbished in 2016

50mm high speed winding mandrels and fixed perforation at 139 mm

Speed: 350/min (15 logs/min)

Roll diameter min: 100 mm (3.9'')

Roll diameter max: 150 mm (5.9'')

Number of ply's: up to 3 ply's

Perforation Lengths: 139mm (5.5")

Tension Control: Variable speed pulleys on rewinder;

Selector Box: Yes, for 6 different sheet control options

Products: Industrial Toilet Paper, Household Toilet Paper, Kitchen towels

Embossing: Steel to Rubber nested embossing with lamination (DESL)

PCMC

Width: 2800mm (110.2")

Nested Embosser & Laminator model NT 3501 (made 2010, refurbished 2016):

Lamination: Yes

Currently set up: Quilted, Perfumed, Eco friendly and Laminated bathroom Tissue but setting could be changed for Kitchen Paper Towel;

Spare rubber roller will be provided: Yes; Spare Sheets with Gears will be provided: Yes; Spare Potential Meters will be provided: Yes;

Spare Pulleys will be provided: Yes; Pattern Roller will be provided: Yes; PCMC core hopper and logstripper conveyor to suit the above will be provided: Yes

PCMC 2.87m Unwind Stand:

Max. rewind diameter: 1870mm (73.5")

Max. roll width: 2870mm (113")

Inner core diameter: 50mm (1.9")

Tension Control: Tension control via Foxboro unit on unwind stand

               Etavoni DB600 Bundler