Verkaufsliste
Hauptbild | Name | Hersteller | Typ | Größe | Kapazität | ||||||||||||||||||||||||||||||||||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
1 verfügbar |
Bütte ca. 30m³Stainless steel |
— | — | about 30m³ | — | ||||||||||||||||||||||||||||||||||||||||||||||||||
— | Mehrere Siebbleche für Fibersorter FS4BMehrere Ersatzsiebbleche für Fibersorter FS4B von Voith bzw. Escher-Wyss in gebrauchtem oder unbenützen Zustand.
|
— | FS4B | — | — | ||||||||||||||||||||||||||||||||||||||||||||||||||
1 verfügbar |
Hochkonsistenzpulper 30 m³ |
— | 30 m³ High consitency pulper | 30 m³ | — | ||||||||||||||||||||||||||||||||||||||||||||||||||
1 verfügbar |
Paper machine 2550 mmmachine width: 2550mm Max. speed: 200 m/min BW range: 30-400grs/m² Supply voltage: 3 x 500 Volts Steam pressure: 4 bar Air pressure: 7 bar Water pressure: 2 bar Water consumption: 40 Lts/Kg Steam consumption: 3.0 Kg/kg PM only from headbox to pope-roll.
MACHINE DESCRIPTION Has produced a wide range of products: Production range is from 30 to 400 GSM running at 50 to 220 m/min. Paper with at reel is 2550 mm max. Capacity is up to 3500 Kg/h. Main characteristics is its formation uniformity CM and MD, gradual drying rate both wet and steam dried. GENERAL DESCRIPTION FORMING SECTION WITH DANDY ROLL It is a Fourdrinier type with removable table for wire change, cantilever couch roll, closed headbox for optimal flow rate at any speed and watermarking Dandy Roll. PRESSES Three 80 kg /cm2 presses, 2 lower felt and a 3rd upper felt, allowing good drying capacity and surface smoothing. Water content after presses is about 50% below 120 GSM. DRYING Consist in a main battery of 18 driers of 1250 mm diameter, in 3 drive sections with drying felts on both sides. Post drying after size press is done with 6 driers, 4 of 1000mm dia and 2 1250mm diameter in one drive section, with automatic paper moisture control. All driers tested at 4 Bar, heated with steam at 3.7 Bars max. All sections covered by a recovery heat hood that allows pocket ventilation at 90 degrees Celcius. SIZE PRESS Two rubber 350 mm diameter rolls working at 20 Kg/cm allows sizing with starch and latex. CALENDER STACK Küsters 400mm dia King roll, 2 intermediate 330mm dia rolls and un upper 400mm dia Queen roll that can be used as a one pass or three pass calender up to 80 Kg/cm. MACHINE DRIVE It is a line shaft with conical pulleys, pneumatic clutch and angular reducer for 11 sections. Motor drive is 300 Kw dc. SECURITY PAPER MACHINE
|
— | — | 2550mm | 3,5 t/h | ||||||||||||||||||||||||||||||||||||||||||||||||||
1 verfügbar |
Kraftliner Karton Papiermaschine 2950 mmKraftliner paper machine 2950 mm Basis Weight: 170 g/m² - 500 g/m² Machine speed: 120 m/min (200 g/m²) Paper Width: 2,950 mm Capacity: 100 tpd
|
— | — | 2950 mm | 100 tpd | ||||||||||||||||||||||||||||||||||||||||||||||||||
— | Papiermaschine Test Liner, Corrugated MediumTest Liner and Corrugated Medium Paper machine Basis Weight : 90 ~ 200 g/㎡ Paper Width : 1). 3,850 mm at Winder Trim Working Speed : 450 m/min with 175 g/㎡. Production Capacity : 436MT/Day on 100% Efficiency bases on 175 g/㎡ |
— | Fourdrinier | 3850 mm at winder | 436 tpd | ||||||||||||||||||||||||||||||||||||||||||||||||||
— | Contaminex CM 20 nahezu Neuzustand |
— | Contaminex CM 20 | 20 | — | ||||||||||||||||||||||||||||||||||||||||||||||||||
— | Siebblech für Wuchtschüttler Voith 1000 K 0,6 mm |
— | Screen plates for vibrating screen | 0,6 mm slot | — | ||||||||||||||||||||||||||||||||||||||||||||||||||
— | Vakuumpumpe CL3002 EdelstahlVakuumpumpe wie Nash CL 3002 in Edelstahlausführung |
— | CL 3002 | — | — | ||||||||||||||||||||||||||||||||||||||||||||||||||
1 verfügbar |
Curioni 4 color Rotary Die CutterCurioni 4 color Rotary Die Cutter Item description 1 Drive for Rotary Die Cutter 1 Extend-o-feed lead-edge feeder 1 Side jogger 4 Raffaello bottom printing flexo unit (2 roll to roll 2 Chambered Doctor Blades) 4 SUCTION GRIP 1 Rotary die cutting unit 1 Synchro Drive 1 Grinder 1 Computer operated automation Master II
|
— | Curioni 4 | — | — | ||||||||||||||||||||||||||||||||||||||||||||||||||
1 verfügbar |
Kleine Papiermaschine für 500 t/MonatProduct: 100% recycled papers / Schrenz, Fluting, Coreboard
Grammage range: 80-240 gsm
Raw Material: wastepaper
Monthly capacity: 500 ton |
— | fourdriner | — | 500 tons/month | ||||||||||||||||||||||||||||||||||||||||||||||||||
1 verfügbar |
2-facher Wendeabwickler2-facher Wendeabwickler Rollen-Breite: 1800mm 1Rolle max. Ø 1200mm Zwischen den 2 Abwickelstangen beträgt der Abstand 95cm 2Rollen mit einem max. Ø 90cm |
— | Turrent unwind station | 1800 mm | — | ||||||||||||||||||||||||||||||||||||||||||||||||||
1 verfügbar |
Gebrauchter Yankee cylinder / GlättzylinderUsed Yankee cylinder Diameter: approx. 4,5m Width: approx. above 3m. Design speed: 2000m/min(6562 ft/min) Weight: approx. 72 To Documentation available |
— | — | — | — | ||||||||||||||||||||||||||||||||||||||||||||||||||
1 verfügbar |
Tissue Papiermaschine 2200 mmGeneral information: Paper machine Capacity: 39 [ton / day] Productioon speed: 360 - 400 [m / min] depending on grammage The range of basis weights produced 30 - 60 gsm Width of the sheet after headbox 2200 [mm].
With waste paper stock preparation - Pulper 15 m³ with feeding conveyor - Pulper discharge machine and first sorter - Hett separator with vibrating screen - Lamort ADS 5 pressure screen - Pressure screen made by Nelba - Lamort CH 3 pressure screen - Maule Kneater with a capacity of 60 t/day - Krofta Clarifier - Voith HD cleaner - Chest with 5 m³ volume
|
— | — | 2060 net width | 39 t/24 h | ||||||||||||||||||||||||||||||||||||||||||||||||||
1 verfügbar |
Kolbenkompressor Mannesmann DemagGebrauchter Kolbenkompressor von Mannesmann Demag in gutem Zustand Betriebsstunden: 8700 Motor: 45kW Druck: 10 bar Glieferte Volumen: 5,8m³/min |
— | ZP80TE | — | 5,8 m³/ min | ||||||||||||||||||||||||||||||||||||||||||||||||||
— | Siebkorb für Metso TL/TAS/TAP 400 0,25mm Schlitz |
— | — | 0,25 mm slot | — | ||||||||||||||||||||||||||||||||||||||||||||||||||
1 verfügbar |
GelenkwelleD=315MM LZ=1370 MM LZ = 1370 MM, LA = 135 MM Flanschdurchmesser 1 315 mm Lochkreisdurchmesser 1 280 +-0,1 mm Flanschbreite 1 22 mm Flanschlochbohrung 1 22 +0,1 +0,3 mm Flanschdurchmesser 2 315 mm Lochkreisdurchmesser 2 280 +-0,1 mm Flanschbreite 2 22 mm Flanschlochbohrung 2 22 +0,1 +0,3 mm Drehmoment max. 80.000 Nm Biegewinkel 15 Grad min. Länge 1.370 mm N=220 UpM Wuchtgüte G6.3 ZKG mit 4x AS Flachschmiernippel mit Verlängerungsrohr, ZS mit einer Madenschraube verstopft incl.FLV - Flanschverschraubung |
— | — | — | — | ||||||||||||||||||||||||||||||||||||||||||||||||||
1 verfügbar |
StapelwenderGebrauchter Stapelwender |
— | — | — | — | ||||||||||||||||||||||||||||||||||||||||||||||||||
— | 3 Siebbleche für Rejectsorter RS 1 |
— | Rejectsorter RS 1 | ca 2,4 mm hole | — | ||||||||||||||||||||||||||||||||||||||||||||||||||
— | Egoutteur 3000 mm / 600 mmEgoutteur Edelstahl Siebbreite ca 3000 mm, Durchmesser ca 600 mm |
— | Egotteur | Wire width 3000 mm | — |