Verkaufsliste
Hauptbild | Name | Hersteller | Typ | Größe | Kapazität |
---|---|---|---|---|---|
1 verfügbar |
Low cons. cleaner Ahlström |
Ahlström | LC cleaner plant | — | — |
1 verfügbar |
Steinwalze 700 x 3420 mm |
— | — | 700 x 3420 mm bale length | — |
1 verfügbar |
Corrugating Board Paper (or Kraft paper) Mill+ Stock PreparationPaper: Kraft (or Corrugating Medium, Test Liner Paper) Basis weight: 31-100 GSM (or 220GSM) Maximum paper width: 6520 mm Production capacity: 400 ton/day Design speed: 1,110 m/min Nominal speed: 400~800mm/min Slight motion speed: 10~60mm/min (At sequence, operation monitoring settings possible) Leveling speed: 100~999.9m/min (At sequence, operation monitoring settings possible) Rate of change per second: 0.1~1m/min/sec (slow speed) 1~5m/min/sec (rapid speed) Change time settings: 10%/200 seconds (10% change time can be set) Coating in size press: max. 1g/m2 (double-side) Reel winding length: 74m Reel winding maximum diameter: 2600mm The number of machine sections: 12 sections The number of motors: 42units (Manufacturing year: 2004) Manufacturing year of electric equipment: 2004
|
Metso / Beloit / Mitsubishi | Twin wire (or four wires) | 6520 mm | 400 t/d |
1 verfügbar |
Rotorpurge 33-1200 Sirpa (like hydrapurge Lamort)Second hand Rotorpurge Type: Rotorpurge Size: 33-1200 Tank capacity: 1200l Max. pressure inside the tank: 5 bars Rotor speed: 330 tr/min Plate perforation: Diam. 12mm Plate / rotor clearance: 0,5 to 1mm
Transmission: motor: 75kw - 1500 tr/min tension: 220/380V / 3Ph / 50Hz pulley pitch diameter: 280/1250mm belt: 4 SPC 4750
Application: position: pulp preparation - pulper discharge production: about 80 tpd
|
Sirpa | Rotorpurge | 33-1200 | 1200l |
1 verfügbar |
Drucksortierer Lamort SP 800Gebrauchter älteren Typs Drucksortierer SP 800
|
Lamort | SP 800 | — | — |
1 verfügbar |
Paper machine 2550 mmmachine width: 2550mm Max. speed: 200 m/min BW range: 30-400grs/m² Supply voltage: 3 x 500 Volts Steam pressure: 4 bar Air pressure: 7 bar Water pressure: 2 bar Water consumption: 40 Lts/Kg Steam consumption: 3.0 Kg/kg PM only from headbox to pope-roll.
MACHINE DESCRIPTION Has produced a wide range of products: Production range is from 30 to 400 GSM running at 50 to 220 m/min. Paper with at reel is 2550 mm max. Capacity is up to 3500 Kg/h. Main characteristics is its formation uniformity CM and MD, gradual drying rate both wet and steam dried. GENERAL DESCRIPTION FORMING SECTION WITH DANDY ROLL It is a Fourdrinier type with removable table for wire change, cantilever couch roll, closed headbox for optimal flow rate at any speed and watermarking Dandy Roll. PRESSES Three 80 kg /cm2 presses, 2 lower felt and a 3rd upper felt, allowing good drying capacity and surface smoothing. Water content after presses is about 50% below 120 GSM. DRYING Consist in a main battery of 18 driers of 1250 mm diameter, in 3 drive sections with drying felts on both sides. Post drying after size press is done with 6 driers, 4 of 1000mm dia and 2 1250mm diameter in one drive section, with automatic paper moisture control. All driers tested at 4 Bar, heated with steam at 3.7 Bars max. All sections covered by a recovery heat hood that allows pocket ventilation at 90 degrees Celcius. SIZE PRESS Two rubber 350 mm diameter rolls working at 20 Kg/cm allows sizing with starch and latex. CALENDER STACK Küsters 400mm dia King roll, 2 intermediate 330mm dia rolls and un upper 400mm dia Queen roll that can be used as a one pass or three pass calender up to 80 Kg/cm. MACHINE DRIVE It is a line shaft with conical pulleys, pneumatic clutch and angular reducer for 11 sections. Motor drive is 300 Kw dc. SECURITY PAPER MACHINE
|
— | — | 2550mm | 3,5 t/h |
1 verfügbar |
Umreifungsmaschine Signode ModulexDrehscheibe: diam. 2.570mm Rollen: 2000 mm |
Signode | Modulex | — | — |
1 verfügbar |
Ballenpresse mit Beschickungsband Balemaster |
Balemaster | EM300 | — | — |
1 verfügbar |
Flachbettstanze Bobst Autoplatine SPO 1600Gebrauchte Maschine: Arbeitsbreite: 160x110 cm Flexo Farbwerk: 1 Maschinengeschwindigkeit: 6000 Bg./h Centerline: I Peripherie: Feeder Easyloader Bj. 1997 + Winkelnutzentrenner Pallmac Bj. 1992
|
BOBST | Autoplatine SPO 1600 | — | — |
1 verfügbar |
KreiselpumpeCentrifugal pump in good condition Made by Allweiler / Germany Capacity: 120 m³/h Pump height: 20 m Required RPM: 1450 Housing made in cast iron |
Allweiler | Centrifugal pump | 270 mm | 120 m³ / h |